How To Pluck 360 Lace Frontal To Look Like Your Own Hair
So how to pluck 360 lace frontal to look like your own hair?
Step 1:First you need to take a few pictures of your natural hairline.The best way to do this is to straighten or stretch your hair and pull your hair into a tight ponytail.Make sure the photos are clear so you can use them as your guide.
Step 2:Place the 360 lace wig on a Styrofoam stand and use pins on the lace to pin it down.You want to have it nice and tight so that it doesn't move.
Step 3:Take a good look at the wig hairline,you will notice that it is pretty dense and that's what you want to avoid.Start plucking some hairs from one side and work your way to the other.
Make sure to use quality tweezers and be careful not to pluck too many hairs.It is best to pluck a little bit at first and see how it looks and if you think that the hairline is still too dense,go back and repeat these steps.
Step 4:Pluck The Lace: Plucking is the process of using a tweezer to pluck out excess hairs around the frontal to make it less bulky.Part the hair on your 360 lace front wigs in two sections and take your fave tweezers and start to pluck the hairline towards you in order to get a more natural look.
Step 5:Create Your Own Part: All 360 lace wigs were not created equal.Some come with a pre-made part down the middle,to the side,with multiple parts,or with no parting at all.
With a free part lace front wig,you'll get to choose where you want your part to lay and create it.You can do this before you create the full wig or after.Just play around with the parting,create a fun hairstyle or keep it down for a more sophisticated and trendy look.
Step 6: Create Natural Edges: Adjust your lace front wig accordingly.Don't forget the baby hairs! For this step separate a small section of the hair from the hairline that you want to use as baby hairs.Use a razor to cut the hair down until the hair is at your desired baby hair length.